Nissan Juke Service and Repair Manual : P1832 TCS operation signal

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.DTC REPRODUCTION PROCEDURE

1. Start the engine and drive at 30 km/h (19 MPH) or more.With CONSULT-III


1. Start the engine and drive at 30 km/h (19 MPH) or more.

2. Perform self-diagnosis for “ALL MODE AWD/4WD”.

Is DTC “P1832” detected? YES >> Proceed to diagnosis procedure. Refer to DLN-64, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS

Perform self-diagnosis for “ABS”.With CONSULT-III


Perform self-diagnosis for “ABS”.

Is any DTCs detected? YES >> Check the DTCs. Refer to BRC-142, "DTC Index".

NO >> GO TO 2.

2.ERASE SELF-DIAGNOSTIC RESULT

1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.With CONSULT-III


1. Erase self-diagnostic results for “ALL MODE AWD/4WD”.

2. Start the engine and drive vehicle at 30 km/h (19 MPH) or more.

3. Check that ABS warning lamp turns OFF.

Does ABS warning lamp turn OFF? YES >> GO TO 3.

NO >> Refer to BRC-212, "Diagnosis Procedure".

3.CHECK TERMINALS AND HARNESS CONNECTORS

Check 4WD control module pin terminals for damage or loose connection with harness connector.

Is inspection result normal? YES >> After turning the ignition switch OFF, perform DTC confirmation procedure again. When DTC “P1832” is detected, Replace 4WD control module. Refer to DLN-91, "Removal and Installation".

NO >> Repair or replace error-detected parts.

    P1831 VDC operation signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DTC REPRODUCTION PROCEDURE With CONSULT-III 1. Start the engine and drive at 30 km/h (19 MPH) or more. 2. Perform self-diagnosis for ...

    P183A coupling temperature sensor right
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    Other materials:

    Take away warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index&qu ...

    Aluminum alloy wheels
    Wash regularly with a sponge dampened in a mild soap solution, especially during winter months in areas where road salt is used. Salt could discolor the wheels if not removed. CAUTION Follow the directions below to avoid staining or discoloring the wheels: • Do not use a cleaner that uses s ...

    Component parts
    Component Parts Location 1. Push-button ignition switch 2. Stop lamp switch Refer to BRC-9, "Component Parts Location" (without EPS), BRC-97, "Component Parts Location" (with EPS) 3. IPDM E/R Refer to PCS-5, "Component Parts Location" 4. Transmission range ...