Preparation

Commercial Service Tools

Other materials:

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

Garage Jack and Safety Stand and 2-Pole Lift
WARNING: • Park the vehicle on a level surface when using the jack. Check to avoid damaging pipes, tubes, etc. under the vehicle. • Never get under the vehicle while it is supported only by the jack. Always use safety stands when you have to get under the vehicle. • Place wheel chocks at ...

Fusible link inspection
How To Check A melted fusible link can be detected either by visual inspection or by feeling with finger tip. If its condition is questionable, use circuit tester or test lamp. 1 :Fusible link CAUTION: • If fusible link should melt, it is possible that critical circuit (power supply or large ...