4WD mode switch

Removal and Installation REMOVAL 1. Remove instrument lower panel. Refer to IP-12, "Exploded View". 2. Remove 4WD mode switch. INSTALLATION Install in the reverse order of removal. ...

Exploded View

1. Transfer gusset 2. Transfer assembly 3. Heat insulator : Vehicle front : N·m (kg-m, ft-lb) ...

Other materials:

B terminal circuit
Description The “B” terminal is constantly supplied with battery power. Diagnosis Procedure CAUTION: Perform diagnosis under the condition that engine cannot start by the following procedure. 1. Remove fuel pump fuse. 2. Crank or start the engine (where possible) until the fuel pressur ...

Removal and installation
IPDM E/R Exploded View 1. IPDM E/R cover A 2. IPDM E/R 3. IPDM E/R cover B Removal and Installation IPDM E/R integrated relays are not serviceable parts, and must not be removed from the unit. REMOVAL 1. Remove battery. 2. Press and expand pawls (A) on lateral side of IPDM E/R cover ...

Intelligent key low battery warning does not operate
Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index&qu ...