Nissan Juke Service and Repair Manual : 4WD mode switch

Removal and Installation

REMOVAL

1. Remove instrument lower panel. Refer to IP-12, "Exploded View".

2. Remove 4WD mode switch.

INSTALLATION

Install in the reverse order of removal.

    4WD control module
    Removal and Installation REMOVAL 1. Turn the ignition switch OFF. 2. Remove front (left side) seat. Refer to SE-27, "Removal and Installation". 3. Remove floor carpet. Refer to INT-23, & ...

    Unit removal and installation
    TRANSFER ASSEMBLY ...

    Other materials:

    Push-button power switch
    WARNING Do not attempt to operate or cycle the push-button power switch while actively driving the vehicle except in a verified, extreme emergency situation. (The primary EV powertrain system completely shuts down and cuts propulsion when the power switch is pushed rapidly three conse ...

    P1615 diffrence of key
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III. Is DTC detected? YES >> Refer to SEC-198, "Diagnosis Procedure". ...

    Shift P warning lamp
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “LCD” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Shift P ...