Nissan Juke Service and Repair Manual : Information display (speed limiter)

Component Function Check

1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION

1. Start engine.

2. Press speed limiter MAIN switch.

3. Drive the vehicle at more than 30 km/h (20 MPH).

CAUTION:
Always drive vehicle at a safe speed.

4. Press SET/COAST switch.

5. Perform a test drive on a flat road conditions. Check that the speedometer indicated the same value as the set speed indicator on the information display while depressing the accelerator pedal until just before a kickdown occurs.

Is the inspection result normal? YES >> INSPECTION END

NO >> Go to EC-788, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC

Check that DTC UXXXX, P0500 or P1574 is not display.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Perform trouble diagnosis for DTC UXXXX.

NO-2 >> Perform trouble diagnosis for DTC P0500. Refer to EC-673, "Diagnosis Procedure".

NO-3 >> Perform trouble diagnosis for DTC P1574. Refer to EC-723, "Diagnosis Procedure".

2.CHECK DTC WITH COMBINATION METER

Check DTC with combination meter. Refer to EC-522, "DTC Index".

Is the inspection result normal? YES >> GO TO 3.

NO >> Perform trouble diagnosis relevant to DTC indicated.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace combination meter.

NO >> Repair or replace.

    Ignition signal
    Component Function Check 1.INSPECTION START Turn ignition switch OFF, and restart engine. Does the engine start? YES-1 >> With CONSULT-III: GO TO 2. YES-2 >> Without CONSULT-III: ...

    Malfunction indicator
    Component Function Check 1.CHECK MI FUNCTION 1. Turn ignition switch ON. 2. Make sure that MI lights up. Is the inspection result normal? YES >> INSPECTION END NO >> Go to EC-789, ...

    Other materials:

    C1609 vehicle speed signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...

    MOD system operation
    The specialized MOD system will automatically turn on and begin scanning your surroundings under the following precise operational conditions: When the electronic shift selector lever is actively placed in the R (Reverse) position. When the overall vehicle speed decreases bel ...

    Front door glass
    Exploded View 1. Front door panel 2. Lower sash (front) 3. Sealing screen 4. Pull handle bracket 5. Front door glass run 6. Front door glass 7. Power window motor 8. Front door regulator assembly 9. Lower sash (rear) : Vehicle front Removal and Installation REMOVAL 1. Fully open ...