Nissan Juke Service and Repair Manual : Malfunction indicator

Component Function Check

1.CHECK MI FUNCTION

1. Turn ignition switch ON.

2. Make sure that MI lights up.

Is the inspection result normal? YES >> INSPECTION END

NO >> Go to EC-789, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC

Check that DTC U1001 is not displayed.

Is DTC detected? YES >> Perform trouble diagnosis for DTC U1001. Refer to EC-569, "Diagnosis Procedure".

NO >> GO TO 2.

2.CHECK COMBINATION METER

Check DTC with combination meter. Refer to MWI-36, "DTC Index".

Is DTC detected? YES >> Perform troubleshooting relevant to DTC indicated.

NO >> GO TO 3.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Exploded View".

NO >> Repair or replace harness or connectors.

    Information display (speed limiter)
    Component Function Check 1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION 1. Start engine. 2. Press speed limiter MAIN switch. 3. Drive the vehicle at more than 30 km/h (20 MPH). CAUTION: ...

    Refrigerant pressure sensor
    Component Function Check 1.CHECK REFRIGERANT PRESSURE SENSOR OVERALL FUNCTION 1. Start engine and warm it up to normal operating temperature. 2. Turn A/C switch and blower fan switch ON. 3. Check ...

    Other materials:

    Turbocharger (If Equipped)
    The turbocharger turbine revolves at extremely high speeds and becomes very hot. Therefore, it is essential to maintain a clean supply of oil flowing through the turbocharger and to follow all required maintenance instructions and operating procedures. • Always use the recommended oil. Follo ...

    Wiring diagram
    Security control system LHD LHD : Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". RHD RHD : Wirin ...

    Magnet clutch
    Component Function Check 1.CHECK MAGNET CLUTCH OPERATION Perform auto active test of IPDM E/R. Refer to PCS-12, "Diagnosis Description" (with Intelligent Key) or PCS- 43, "Diagnosis Description" (without Intelligent Key). Does it operate normally? YES >> INSPECTION ...