Inspection - Periodic maintenance - Driveline transfer: TY21B - Nissan Juke Service and Repair Manual:

Nissan Juke Service and Repair Manual : Inspection

Nissan Juke Service and Repair Manual / Driveline transfer: TY21B / Periodic maintenance / Inspection

OIL LEAKAGE

Check transfer surrounding area (oil seal, drain plug, filler plug, and transfer case etc.) for oil leakage.

OIL LEVEL

1. Remove filler plug (1) and gasket. Then check that oil is filled up from mounting hole for the filler plug.

CAUTION: Vehicle front

CAUTION:
Never start engine while checking oil level

2. Before installing filler plug, set a new gasket. Install filler plug on transfer and tighten to the specified torque. Refer to DLN-113, "Exploded View".

CAUTION:
Never reuse gasket.

Draining

1. Run the vehicle to warm up the transfer unit sufficiently. 2. Stop the engine and remove the drain plug (1) and gascket to drain the transfer oil. 3. Before installing drain plug, set a new gask ...

Other materials:

Power supply and ground circuit
Diagnosis Procedure 1.CHECK FUSE AND FUSIBLE LINK Check that the following fuse and fusible link are not blown. Is the fuse fusing? YES >> Replace the blown fuse or fusible link after repairing the affected circuit if a fuse or fusible link is blown. NO >> GO TO 2. 2.CHECK ...

B2621 inside antenna
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “INSIDE ANT DIAGNOSIS” in “WORK SUPPORT” mode. 3. Perform inside key antenna (“INSIDE ANT DIAGNOSIS”) on “WORK ...

Diagnosis system (BCM) (with intelligent key system)
Common item : consult-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the following for ...