Wiring diagram

4WD SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Inform ...

Diagnosis and repair work flow

Work Flow DETAILED FLOW 1.INTERVIEW FROM THE CUSTOMER Clarify customer complaints before inspection. First of all, perform an interview utilizing DLN-37, "Diagnostic Work Sheet" and re ...

Other materials:

Blower motor
Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >> GO TO 2. B >> GO TO 7. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 15A fuses (Nos. 14 and 16, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Connector and ...

Front seat (2WD)
Exploded View DRIVER SEAT LHD models 1. Headrest 2. Headrest holder (locked) 3. Headrest holder (free) 4. Seatback heater unit 5. Inner lower cover 6. Seatback trim 7. Seatback pad 8. Seat cushion inner finisher 9. Reclining device inner cover 10. Anchor bolt 11. Seat belt buck ...

P0107, P0108 atmospheric pressure sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swi ...