Nissan Juke Service and Repair Manual : Refilling

1. Remove filler plug (1) and gasket. Then fill oil up to mounting hole for the filler plug.

Oil and viscosity : Refer to MA-13, "Fluids: Vehicle front


Oil and viscosity : Refer to MA-13, "Fluids and Lubricants".

Oil capacity : Refer to DLN-117, "General Specifications".

CAUTION:


CAUTION:
Carefully fill the oil. (Fill up for approximately 3 minutes.)

2. Leave the vehicle for 3 minutes, and check the oil level again.

3. Before installing filler plug, set a new gasket. Install filler plug on transfer and tighten to the specified torque. Refer to DLN-113, "Exploded View".

CAUTION:
Never reuse gasket.

    Draining
    1. Run the vehicle to warm up the transfer unit sufficiently. 2. Stop the engine and remove the drain plug (1) and gascket to drain the transfer oil. 3. Before installing drain plug, set a new gask ...

    Other materials:

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

    Security indicator lamp does not turn on or blink
    Description Security indicator lamp does not blink when ignition switch is in a position other than ON. NOTE: • Before performing the diagnosis, check “Work Flow”. Refer to SEC-47, "Work Flow". • Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE ...

    Road accident precautions
    WARNING In the event of a vehicular collision, please follow these safety protocols: If your Nissan Leaf remains drivable, maneuver the vehicle to a secure location away from active traffic. Once stopped, engage the Park (P) position, apply the parking brake firmly, and power off ...