Nissan Juke Service and Repair Manual : Door & Lock type 4
- How to use this manual
- Precaution
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconne
- Precaution for Procedure without Cowl Top Cover
- Work
- Preparation
- System description
- Component parts
- Power door lock system
- Remote keyless entry system
- Back door opener system
- Diagnosis system (BCM)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- Back door opener actuator
- Back door opener switch
- Door lock actuator
- Door lock and unlock switch
- Door switch
- Hazard function
- Key switch
- Keyfob battery
- Remote keyless entry receiver
- Unlock sensor
- Symptom diagnosis
- Door does not lock/unlock with door lock and unlock switch
- Door does not lock/unlock with driver side door lock knob or door key cylinder
- Door does not lock/unlock with keyfob
- Back door does not opened
- ANTI-HIJACK function does not operate
- Vehicle speed sensing auto lock operation does not operate
- IGN off interlock door unlock function does not operate
- P range interlock door lock/unlock function does not operate
- Auto door lock operation does not operate
- Unlock link function does not operate
- Key out interlock door unlock function does not operate
- Key reminder function does not operate
- Hazard reminder operation does not operate
- Squeak and rattle trouble diagnoses
- Removal and installation
Keyfob battery
Exploded View
1. Upper case
2. Key
3. Switch cover
4. Switch rubber
5. Board surface
6. Battery
7. plate
8. Lower case
9. Screw
Removal and Installation
REMOVAL
1. Remove screw (9) ...
How to use this manual
APPLICATION NOTICE
Information
Check the vehicle type to use the service information in this section.
...
Other materials:
Diagnosis system (BCM)
Common item : consult-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for ...
Diagnosis system (navi control unit)
Diagnosis Description
On-Board Diagnosis Item
• On-board diagnosis is performed in service test mode.
• On-board diagnosis checks if the system operates normally.
Service test mode
METHOD OF STARTING
1. Start the engine.
2. Turn OFF audio.
3. While pressing the “SET UP” switch, ...
Engine maintenance (MR16DDT)
Drive belt
DRIVE BELT : Exploded View
1. Alternator
2. Drive belt auto-tensioner
3. Crankshaft pulley
4. A/C compressor
5. Water pump
6. Drive belt
A. Possible use range
B.
Range when new drive belt is installed
C. Indicator
DRIVE BELT : Checking
WARNING:
Perform this step when ...
