Nissan Juke Service and Repair Manual : Hazard reminder operation does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM AND COMBINATION METER

Check that DTC is not detected with BCM and combination meter.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Refer to BCS-141, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index". (Combination meter) 2.CHECK “HAZARD LAMP SET” SETTING IN “WORK SUPPORT

1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III.

2. Select “HAZARD LAMP SET” in “WORK SUPPORT” mode.

3. Check “HAZARD LAMP SET” in “WORK SUPPORT”.

Refer to DLK-502, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT) (Without Super Lock)".

Is the inspection result normal? YES >> GO TO 3.

NO >> Set “HAZARD LAMP SET” in “WORK SUPPORT”.

3.CHECK HAZARD WARNING LAMP

Check hazard warning lamp.

Refer to DLK-525, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Key reminder function does not operate
    Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switch. Refer to DLK-520, "Component Function Check". Is the inspection result normal? YES >> ...

    Squeak and rattle trouble diagnoses
    Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the ...

    Other materials:

    Component parts
    Component Parts Location 1. Door request switch (driver side) 2. Door mirror (driver side) 3. Remote keyless entry receiver Refer to DLK-21, "Component Parts Location" 4. Door mirror remote control switch 5. BCM Refer to BCS-6, "BODY CONTROL SYSTEM : Component Parts Loca ...

    Back door lock
    Exploded View 1. Back door lock assembly 2. TORX bolt 3. Back door striker : Do not reuse : N·m (kg-m, ft-lb) : Body grease Door lock DOOR LOCK : Removal and Installation REMOVAL 1. Remove the back door lower finisher. Refer to INT-35, "BACK DOOR LOWER FINISHER : Removal and I ...

    Magnet clutch
    Component Function Check 1.CHECK MAGNET CLUTCH OPERATION Perform auto active test of IPDM E/R. Refer to PCS-12, "Diagnosis Description" (with Intelligent Key) or PCS- 43, "Diagnosis Description" (without Intelligent Key). Does it operate normally? YES >> INSPECTION ...