Auto door lock operation does not operate

Diagnosis Procedure 1.CHECK “AUTO LOCK SET” SETTING WITH CONSULT-III 1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III. 2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode. 3. Check “AUTO LOCK ...

Key out interlock door unlock function does not operate

Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mod ...

Other materials:

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

Coil spring
Exploded View 1. Upper rubber seat 2. Coil spring 3. Lower rubber seat 4. Rear suspension beam Removal and Installation REMOVAL 1. Remove tires. Refer to WT-7, "Removal and Installation". 2. Set jack under rear suspension beam. CAUTION: • Never damage the suspension beam wi ...

P17B8 high clutch solenoid
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...