Nissan Juke Service and Repair Manual : Auto door lock operation does not operate

Nissan Juke Service and Repair Manual / Door & Lock type 4 / Symptom diagnosis / Auto door lock operation does not operate

Diagnosis Procedure

1.CHECK “AUTO LOCK SET” SETTING WITH CONSULT-III

1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III.

2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode.

3. Check “AUTO LOCK SET” in “WORK SUPPORT”.

Refer to DLK-502, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT) (Without Super Lock)".

Is the inspection result normal? YES >> GO TO 2.

NO >> Set “AUTO LOCK SET” in “WORK SUPPORT”.

2.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    P range interlock door lock/unlock function does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” i ...

    Unlock link function does not operate
    Diagnosis Procedure 1.REPLACE BCM • Replace BCM. Refer to BCS-161, "Removal and Installation". • Confirm the operation after replacement. Is the result normal? YES >> INSPEC ...

    Other materials:

    CVT position
    Inspection and Adjustment INSPECTION 1. Turn ON the ignition switch with the selector lever at the P position. 2. Press the selector button with the brake pedal depressed, and confirm that the lever can be shifted to positions other than P. Also confirm that shifting is not allowed from the P ...

    Fuel pump
    Component Function Check 1.CHECK FUEL PUMP FUNCTION 1. Turn ignition switch ON. 2. Pinch fuel feed hose with two fingers. Fuel pressure pulsation should be felt on the fuel feed hose for 1 second after ignition switch is turned ON. Is the inspection result normal? YES >> INSPECTION END ...

    A-bag branch line circuit
    Diagnosis Procedure WARNING: • Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.) • Never use unspecified tester or other measuring device. 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. D ...