Nissan Juke Owners Manual : Keyfob

Replace the battery in the keyfob as follows:

1. Remove the screw.

2. Insert a small screwdriver into the slit of the corner and twist it to separate the upper part from the lower part. Use a cloth to protect the casing.

3. Replace the battery with a new one.

Recommended battery:

CR1620 or equivalent

• Do not touch the internal circuit and electric terminals as doing so could cause a malfunction.

• Hold the battery by the edges. Holding the battery across the contact points will seriously deplete the storage capacity.

• Make sure that the + side faces the bottom of the case.

4. Close the lid securely and install the screw.

5. Operate the buttons to check its operation.

See a NISSAN dealer if you need any assistance for replacement.

FCC Notice:

For USA:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For Canada:

This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

    Key battery replacement
    CAUTION Be careful not to allow children to swallow the battery and removed parts. ...

    Intelligent Key
    Replace the battery in the Intelligent Key as follows: 1. Remove the mechanical key from the Intelligent Key. 2. Insert a small screwdriver into the slit of the corner and twist it to separate ...

    Other materials:

    Additional service when replacing ECM
    Description When replacing ECM, this procedure must be performed. Work Procedure 1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION KEY IDS Refer to SEC-50, "ECM : Work Procedure". >> GO TO 2. 2.PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNIN ...

    Electric controlled coupling
    Exploded View 1. Filler plug 2. Gasket 3. Drain plug 4. Breather tube 5. Clip 6. Breather hose 7. Breather 8. sub-harness clip 9. sub-harness 10. Rear cover 11. Center stem 12. Side bearing (right) 13. Side bearing adjusting shim (right) 14. Side oil seal (right) 15. Conne ...

    System (power door lock system)
    System Diagram System Description DOOR LOCK FUNCTION Door Lock and Unlock Switch • The door lock and unlock switch (driver side) is build into power window main switch. • Interlocked with the locking operation of door lock and unlock switch, door lock actuators of all doors are locke ...