Passenger compartment

CAUTION Never use a fuse of a higher or lower amperage rating than that specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electrical equipment does ...

Keyfob

Replace the battery in the keyfob as follows: 1. Remove the screw. 2. Insert a small screwdriver into the slit of the corner and twist it to separate the upper part from the lower part. Use a clot ...

Other materials:

Headlamp
Exploded View REMOVAL 1. Headlamp assembly 2. EPT sealer [2.8 mm (0.110 in)] : Do not reuse : N·m (kg-m, in-lb) DISASSEMBLY 1. Back cover 2. Halogen bulb 3. Headlamp housing assembly 4. Retaining spring 5. EPT sealer [2.8 mm (0.110 in)] : Do not reuse Removal and Installation ...

Front stabilizer
Exploded View 1. Stabilizer bar 2. Stabilizer clamp 3. Stabilizer bushing 4. Stabilizer connecting rod 5. Strut assembly 6. Front suspension member : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Remove tires. Refer to WT-7, "Removal and Installation". 2. Remove f ...

Service
• Never use electrical test equipment to check SRS circuits unless instructed to in this Service Manual. • Before servicing the SRS, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more. For approximately 3 minutes after the cables are removed, it is st ...