Door switch

Exploded View 1. Door switch 2. TORX bolt Removal and Installation REMOVAL Remove the TORX bolt (A), and then remove door switch (1). INSTALLATION Install in the reverse order of removal. ...

Keyfob battery

Exploded View 1. Upper case 2. Key 3. Switch cover 4. Switch rubber 5. Board surface 6. Battery 7. plate 8. Lower case 9. Screw Removal and Installation REMOVAL 1. Remove screw (9) ...

Other materials:

Headlamp aiming system (manual)
Component Inspection 1.CHECK HEADLAMP AIMING SWITCH 1. Remove headlamp aiming switch. 2. Check resistance among each headlamp aiming switch terminal. Is the inspection result normal? YES >> Headlamp aiming switch is normal. NO >> Replace the headlamp aiming switch. ...

S terminal circuit
Description The output voltage of the alternator is controlled by the IC voltage regulator at the “S” terminal detecting the input voltage. The “S” terminal circuit detects the battery voltage to adjust the alternator output voltage with the IC voltage regulator. Diagnosis Procedure 1.CH ...

B26F8 BCM
DTC Logic DTC DETECTION LOGIC NOTE: DTC B26F8 can be detected even though the related circuit is not used in this vehicle. DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON and wait 1 second. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” u ...