Keyfob ID registration

Description Perform the following procedure after BCM is replaced or when new keyfob ID is registered NOTE: When registering the keyfob ID, perform only one procedure to simultaneously register ...

Back door opener actuator

Diagnosis Procedure 1.CHECK BACK DOOR OPENER ACTUATOR INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect back door opener assembly connector. 3. Check voltage between back door opener assembl ...

Other materials:

P0605 ECM
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...

Ignition position warning function does not operate
Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM. Is the inspection result normal? YES >> GO TO 2. NO >> Refer to BCS-67, "DTC Index". 2.CHECK POWER DOOR LOCK OPERATION Check power door lock operation. Does door lock/unlock with d ...

PTC heater control unit connection recognition signal circuit
Diagnosis Procedure 1.CHECK PTC HEATER CONTROL UNIT CONNECTION RECOGNITION SIGNAL 1. Turn ignition switch ON. 2. Check voltage between combination meter harness connector and ground. Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 2. 2.CHECK PTC HEATER CONTR ...