Description

Perform the following procedure after BCM is replaced or when new keyfob ID is registered NOTE

:
When registering the keyfob ID, perform only one procedure to simultaneously register both ID (IMMOBILIZER ID and keyfob ID).

Work Procedure

1.STEP 1

Close all doors.

>> GO TO 2.

2.STEP 2

Operate lock using the driver side door lock and unlock switch.

>> GO TO 3.

3.STEP 3

1. Remove and insert the key into the ignition key 6 times within 10seconds (turning the key switch from OFF to ON counts as 1 time).

2. Hazard warning lamp blinks(2 times).

NOTE

:
On the sixth key insertion, keep the key in the cylinder with the key switch ON.

Does the hazard lamp blink? YES >> GO TO 4.

NO >> GO TO 1.

4.STEP 4

Within 3 seconds after the hazard lamp blinks, turn ignition switch to the ACC position and operate lock using the driver side door lock and unlock switch.

>> GO TO 5.

5.STEP 5

1. Press the lock or unlock button of the keyfob to be added.

2. All doors unlock simultaneously.

3. Hazard warning lamp blinks(2 times).

4. Key ID is registered.

Is key ID registered? YES-1 >> When adding a keyfob: GO TO 6.

YES-2 >> When ending registration: GO TO 8.

NO >> GO TO 1.

6.STEP 6

Operate lock using the driver side door lock and unlock switch.

>> GO TO 7.

7.STEP 7

1. Press the lock or unlock button of the keyfob to be added.

2. All doors unlock simultaneously.

3. Hazard warning lamp blinks(2 times).

4. Key ID is registered.

Is key ID registered? YES-1 >> When adding a keyfob: GO TO 6.

YES-2 >> When ending registration: GO TO 8.

NO >> GO TO 6.

8.STEP 8

Open the front door driver side.

>> REGISTRATION END