Nissan Juke Service and Repair Manual : B2098 ignition relay on stuck

Description

• IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication.

• Turn the ignition relay OFF by pressing the push-button ignition switch once when the vehicle speed is 4 km/ h (2.5 MPH) or less.

• Turn the ignition relay OFF with the following operation when the vehicle speed is more than 4 km/h (2.5 MPH) or when an abnormal condition occurs in CAN communication from the combination meter (Emergency OFF)

- Press and hold the push-button ignition switch for 2 seconds or more.

- Press the push-button ignition switch 3 times within 1.5 seconds.

NOTE

:
The ignition relay does not turn ON for 3 seconds after emergency OFF even if the push-button ignition switch is pressed.

DTC Logic

DTC DETECTION LOGIC

1.PERFORM DTC CONFIRMATION PROCEDURE


1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “IPDM E/R” using CONSULT-III.

Is DTC detected? YES >> Refer to PCS-31, "Diagnosis Procedure".

NO >> INSPECTION END.

Diagnosis Procedure

1.PERFORM SELF DIAGNOSIS

1. Turn the ignition switch ON.

2. Erase “Self Diagnostic Result” of IPDM E/R.

3. Turn the ignition switch OFF, and wait for 1 second or more.

4. Turn the ignition switch ON. Check “Self Diagnostic Result” again.

Is DTC “B2098” displayed? YES >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation".

NO >> Refer to GI-42, "Intermittent Incident".

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excelle ...

    B2099 ignition relay off stuck
    Description • IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication. • Turn the ignition relay OFF by pressing the push-button ignit ...

    Other materials:

    PTC heater
    Component Function Check 1.CHECK PTC HEATER OPERATION 1. Start the engine. 2. Operate fan control dial. 3. Operate temperature control dial to full hot position. 4. Check for warm air at discharge air outlet. NOTE: • Engine must be cold. • Battery must be charged. Is the inspection re ...

    Cargo cover (if so equipped)
    WARNING • Never put anything on the cargo cover, no matter how small. Any object on it could cause an injury in an accident or sudden stop. • Do not leave the cargo cover in the vehicle with it disengaged from the holder. • The child restraint top tether strap may be damaged by contact wi ...

    P1588 G sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. > ...