Nissan Juke Service and Repair Manual : P0605 ECM

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A

1. Turn ignition switch ON.

2. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Go to EC-683, "Diagnosis Procedure".

NO >> GO TO 3.

3.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B

1. Turn ignition switch ON and wait at least 1 second.

2. Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.

3. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Go to EC-683, "Diagnosis Procedure".

NO >> GO TO 4.

4.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C

1. Turn ignition switch ON and wait at least 1 second.

2. Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.

3. Repeat step 2 for 32 times.

4. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Go to EC-683, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

1. Erase DTC.

2. Perform DTC CONFIRMATION PROCEDURE.

See EC-683, "DTC Logic".

Is the 1st trip DTC P0605 displayed again? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE ECM

1. Replace ECM.

2. Perform EC-541, "Work Procedure".

>> INSPECTION END

    P0603 ECM
    Description ECM has the memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the Idle Air Volume Learning value memory, etc. even when the ignition switch is tu ...

    P0607 ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC. Is DTC detected? YES >> Proceed to EC-685, &quo ...

    Other materials:

    Injection tube and fuel injector
    Exploded View 1. Spill hose 2. Injection tube 3. Fuel injector 4. Heat protection washer 5. Fuel injector bracket 6. Fuel injector bracket spacer 7. Fuel rail stud bolt 8. Fuel rail 9. High pressure protection cover (lower) 10. Injection tube 11. High pressure supply pump 12. H ...

    Removal and Installation
    REMOVAL 1. Disconnect accelerator pedal position sensor harness connector. 2. Loosen mounting bolts, and remove accelerator pedal assembly. CAUTION: • Never disassemble accelerator pedal assembly. Never remove accelerator pedal position sensor from accelerator pedal assembly. • Avoid i ...

    Periodic maintenance
    IDLE SPEED Inspection 1.CHECK IDLE SPEED With CONSULT-III Check idle speed in “DATA MONITOR” mode with CONSULT-III. With GST Check idle speed with Service $01 of GST. Without CONSULT-III Check idle speed by installing the pulse type tachometer clamp on the loop wire or on suitable ...