Nissan Juke Service and Repair Manual : P0603 ECM

Description

ECM has the memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the Idle Air Volume Learning value memory, etc. even when the ignition switch is turned OFF.

DTC Logic


DTC Logic

DTC DETECTION LOGIC

*: This self-diagnosis is not for ECM power supply circuit, even though “ECM


*: This self-diagnosis is not for ECM power supply circuit, even though “ECM BACK UP/CIRCUIT” is displayed on CONSULT-III screen.

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON wait at least 10 seconds.

2. Turn ignition switch OFF and wait at least 5 minutes 3. Turn ignition switch ON, wait at least 10 seconds.

4. Repeat step 2 and 3 for five times.

5. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Go to EC-681, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

1. Erase DTC.

2. Perform DTC CONFIRMATION PROCEDURE.

See EC-681, "DTC Logic".

Is the 1st trip DTC P0603 displayed again? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE ECM

1. Replace ECM.

2. Perform EC-541, "Work Procedure".

>> INSPECTION END

    P0524 engine oil pressure
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0524 is displayed with DTC P0520 or P0075, perform trouble diagnosis for DTC P0520 or P0075 first. Refer to EC-674, "DTC Logic" or EC-583, & ...

    P0605 ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 se ...

    Other materials:

    Locking with power door lock switch
    Driver’s armrest Operating the power door lock switch will lock or unlock all the doors. The switch is located on the driver’s door armrest. To lock the doors, push the power door lock switch to the lock position 1 with the driver’s door open, then close the door. When locking the doo ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

    Diagnosis system (ECM)
    Diagnosis description Diagnosis description : 1st Trip Detection Logic and Two Trip Detection Logic When a malfunction is detected for the first time, 1st trip DTC and 1st trip Freeze Frame data are stored in the ECM memory. The MIL will not illuminate at this stage. <1st trip> If the s ...