Nissan Juke Service and Repair Manual : P0607 ECM

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC.

Is DTC detected? YES >> Proceed to EC-685, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Erase DTC.

3. Perform DTC confirmation procedure. Refer to EC-685, "DTC Logic".

4. Check DTC.

Is the DTC P0607 displayed again? YES >> Replace ECM. Refer to EC-805, "Removal and Installation".

NO >> INSPECTION END

    P0605 ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 se ...

    P0643 sensor power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 se ...

    Other materials:

    System
    NISSAN dynamic control system NISSAN DYNAMIC CONTROL SYSTEM : System Description SYSTEM DIAGRAM • *1: M/T models except for K9K engine models • *2: CVT models MULTI DISPLAY UNIT INPUT/OUTPUT SINGNAL Output signal SYSTEM DESCRIPTION • The multi display unit receives necessary info ...

    Service Notice or Precaution
    OBD SELF-DIAGNOSIS (WITH OBD) • CVT self-diagnosis is performed by the TCM in combination with the ECM. The results can be read through the blinking pattern of the malfunction indicator (MI). Refer to the table on TM-159, "CONSULT-III Function (TRANSMISSION)" for the indicator use ...

    B2581, B2582 intake sensor
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 141, "DTC Logic". • If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. HAC-142, "DTC ...