Nissan Juke Service and Repair Manual : Removal and Installation

REMOVAL

1. Disconnect accelerator pedal position sensor harness connector.

2. Loosen mounting bolts, and remove accelerator pedal assembly.

CAUTION:
• Never disassemble accelerator pedal assembly. Never remove accelerator pedal position sensor from accelerator pedal assembly.

• Avoid impact from dropping etc. during handling.

• Be careful to keep accelerator pedal assembly away from water

.

INSTALLATION

Note the following, and install in the reverse order of removal.

• Insert the locating pin while inserting the locating hook in to the break pedal bracket. Tighten mounting bolts to accelerator pedal assembly.

CAUTION:
Never squeeze the locating hook into the break pedal bracket when inserting the locating pin into the hole on the brake pedal bracket side.

    Exploded View
    1. Accelerator pedal assembly 2. Brake pedal bracket A. Locating hook B. Locating pin : N·m (kg-m, in-lb) ...

    Inspection
    INSPECTION AFTER INSTALLATION • Check accelerator pedal moves smoothly within the whole operation range when it is fully depressed and released. • Check accelerator pedal securely returns to ...

    Other materials:

    ECO Mode
    The ECO mode is a specialized driving setting designed to optimize your energy consumption. By smoothing out throttle response—effectively reducing acceleration compared to the same accelerator pedal input in the standard D (Drive) position—this mode helps you extract the m ...

    P0226 APP sensor
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or ...

    Compressor dose dot operate
    Description SYMPTOM Compressor dose not operate. Diagnosis Procedure NOTE: • Perform self-diagnoses with CONSULT-III before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis. • Check that refrigerant is enclosed in cooler cycle normally. If refrig ...