Nissan Juke Service and Repair Manual : Accelerator control system

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as AIR BAG and SEAT BELT PRE-TENSIONER, ...

Other materials:

Engine stand setting
Preparing the engine to be on the stand Before the engine is mounted on the engine sub-attachment, the engine's electrical harness must be removed and the engine oil drained. 1. Remove the multifunction support. 2. Remove the coolant inlet pipe on the water pump. 3. Place the rods (A), ...

Draining
1. Run the vehicle to warm up the transfer unit sufficiently. 2. Stop the engine and remove the drain plug (1) and gascket to drain the transfer oil. 3. Before installing drain plug, set a new gasket. Install drain plug on the transfer and tighten to the specified torque. Refer to DLN- 113, &qu ...

P17B8 high clutch solenoid
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...