Nissan Juke Service and Repair Manual : Back door does not opened

Diagnosis Procedure

1.CHECK BACK DOOR OPENER SWITCH

Check back door opener switch.

Refer to DLK-513, "Component Function Check".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK BACK DOOR OPENER ACTUATOR

Check back door opener actuator.

Refer to DLK-512, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CHECK VEHICLE SPEED SIGNAL

Check vehicle speed signal.

Refer to MWI-46, "DTC Logic".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.REPLACE BCM

1. Replace BCM. Refer to BCS-161, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Door does not lock/unlock with keyfob
    Diagnosis Procedure 1.CHECK POWER DOOR LOCK OPERATION Check power door lock operation. Does door lock/unlock with door lock and unlock switch? YES >> GO TO 2. NO >> Go to DLK-534, ...

    ANTI-HIJACK function does not operate
    Diagnosis Procedure 1.CHECK “DOOR LOCK–UNLOCK SET” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK-UNLOCK SET” in “WORK SUPP ...

    Other materials:

    P183D side G sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...

    Rear wiper auto stop signal circuit
    Component Function Check 1.CHECK REAR WIPER (AUTO STOP) OPERATION CONSULT-III DATA MONITOR 1. Select “WIPER” of BCM data monitor item. 2. Operate the rear wiper. 3. Check that “RR WIPER STOP” changes to “On” and “Off” linked with the wiper operation. Is the status of item n ...

    Blower fan resistor
    Exploded View 1. A/C unit assembly 2. Blower fan resistor*1 3. Sub harness*1 4. Power transistor*2 5. Sub harness*2 6. Blower motor • *1: Manual air conditioner • *2: Automatic air conditioner Removal and Installation REMOVAL 1. Remove instrument panel assembly. Refer to IP-13, ...