Nissan Juke Service and Repair Manual : P060B ECM

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Erase DTC.

3. Turn ignition switch OFF and wait for 20 seconds.

4. Turn ignition switch ON and perform the self-diagnosis.

Is the DTC P060B displayed again? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE ECM

1. Replace ECM.

2. Go to EC-879, "Work Procedure".

>> INSPECTION END

    P060A ECM
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON ...

    P061A ECM
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON ...

    Other materials:

    Diagnosis system (IPDM E/R) (without intelligent key system)
    Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp (only for K9K engine models) • Rear window defogger • Front wiper motor • Parking lamp • ...

    P1226 TP sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following proced ...

    Connector information
    How to Read Connector Type 1 : Connector model 2 : Cavity 3 : Male (M) and female (F) terminals 4 : Connector color 5 : Special type B Body Harness D Door Harness E Engine Room Harness F Engine Control Harness M Ma ...