Work

• After removing and installing the opening/closing parts, be sure to carry out fitting adjustments to check their operational. • Check the lubrication level, damage, and wear of each part. If nec ...

System description

...

Other materials:

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

Refilling
1. IInstall reservoir tank if removed, and install radiator drain plug. CAUTION: Be sure to clean drain plug and install with new O-ring. Radiator drain plug : Refer to CO-17, "Exploded View". • If water drain plugs on cylinder block are removed, close and tighten them. Refer to EM ...

Fillet molding
Exploded View 1. Grommet 2. Clip 3. Clip 4. Front fillet molding 5. Rear fillet molding : Pawl : Do not reuse Front fillet molding FRONT FILLET MOLDING : Removal and Installation REMOVAL 1. Remove front fillet molding fixing clips. 2. Remove front fillet molding front side fixing pa ...