Nissan Juke Service and Repair Manual : Engine Mechanical HR16DE
- Precautions
- Precaution for Procedure without Cowl Top Cover
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Draining Engine Coolant
- Disconnecting Fuel Piping
- Removal and Disassembly
- Inspection, Repair and Replacement
- Assembly and Installation
- Parts Requiring Angle Tightening
- Liquid Gasket
- Preparation
- Basic inspection
- Compression pressure
- Symptom diagnosis
- Periodic maintenance
- Removal and installation
- Drive belt idler pulley
- Air cleaner and air duct
- Intake manifold
- Exhaust manifold
- Oil pan (lower)
- Fuel injector and fuel tube
- Ignition coil, spark plug and rocker cover
- Timing chain
- Camshaft
- Oil seal
- Cylinder head
- Unit removal and installation
- Unit disassembly and assembly
- Service data and specifications (SDS)
Main Bearing
MAIN BEARING GRADE TABLE (ALL JOURNALS)
UNDERSIZE TABLE
MAIN BEARING OIL CLEARANCE
...
Precautions
...
Other materials:
Keyfob id registration
Description
Perform the following procedure after BCM is replaced or when new keyfob ID
is registered
NOTE:
When registering the keyfob ID, perform only one procedure to simultaneously
register both ID (IMMOBILIZER
ID and keyfob ID).
Work Procedure
1.STEP 1
Close all doors.
>> GO ...
Additional service when replacing TCM
Description
Always perform the following items when the TCM is replaced.
CHECK LOADING OF CALIBRATION DATA
• The TCM acquires calibration data (individual characteristic value) of each
solenoid that is stored in the
ROM assembly (in the control valve). This enables the TCM to perform accurat ...
Drive belt
Checking Drive Belts
WARNING:
Be sure to perform when the engine is stopped.
1. Inspect belts for cracks, fraying, wear and oil. If necessary,
replace.
2. Evaluate manually if the belt is enough tensioned (tension cannot
be measured by way of frequency meter).
CAUTION:
Auto-tensioner must ...
