Symptom diagnosis

Noise, vibration and harshness (NVH) Troubleshooting NVH troubleshooting Chart 1. Locate the area where noise occurs. 2. Confirm the type of noise. 3. Specify the operating condition of engine. ...

Drive belt

Checking • Inspection should be done only when engine is cold or over 30 minutes after the engine is stopped. 1 : Alternator 2 : Water pump 3 : Crankshaft pulley 4 : A/C compressor 5 : Idler ...

Other materials:

DPF (diesel particulate filter) data clear
Description Perform ???DIESEL PARTICULATE FILTER DATA CLEAR??? in ???WORK SUPPORT??? mode with CONSULT-III when oxidation catalyst with diesel particulate filter is replaced as new one. Based on the signal from sensors ECM estimates the amount of particulate matter in diesel particulate filte ...

Engine stand setting
Preparing the engine to be on the stand Before the engine is mounted on the engine sub-attachment, the engine's electrical harness must be removed and the engine oil drained. 1. Remove the multifunction support. 2. Remove the coolant inlet pipe on the water pump. 3. Place the rods (A), ...

Anti-hijack function does not operate
Diagnosis Procedure 1.CHECK “DOOR LOCK–UNLOCK SET” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT” mode. 3. Check “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT” Refer to DLK-41, "DOOR ...