Nissan Juke Service and Repair Manual : Main Bearing


Connecting Rod Bearing


    Cylinder Block
    *: After installing in connecting rod ...

    Other materials:

    P1830 ABS operation signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DTC REPRODUCTION PROCEDURE With CONSULT-III 1. Start the engine and drive at 30 km/h (19 MPH) or more. 2. Perform self-diagnosis for “ALL MODE AWD/4WD”. Is DTC “P1830” detected? YES >> Proceed to diagnosis procedure. Refer ...

    Side oil seal
    Removal and Installation REMOVAL 1. Remove front drive shafts. (MR16DDT) Refer to FAX-22, "LEFT SIDE : Removal and Installation" (LEFT SIDE) and FAX-24, "RIGHT SIDE : Removal and Installation" (RIGHT SIDE). 2. Remove front drive shafts. (K9K) Refer to FAX-78, "LEFT SID ...

    P0643 sensor power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...