Commercial Service Tools

...

Camshaft valve clearance

Inspection and Adjustment INSPECTION Perform inspection as follows after removal, installation or replacement of camshaft or valve-related parts, or if there is unusual engine conditions regardin ...

Other materials:

TCM
Exploded View 1. Bracket 2. TCM :Vehicle front : N·m (kg-m, in-lb) Removal and Installation NOTE: When replacing TCM and transaxle assembly as a set, replace transaxle assembly first and then replace TCM. Refer to TM-374, "Description". REMOVAL 1. Remove the battery. Refer ...

P0078 EVT control solenoid valve
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Oil cooler
Exploded View 1. Cylinder block 2. Water pipe 3. O-ring 4. O-ring 5. O-ring 6. Oil cooler 7. Connecting stud 8. O-ring 9. Oil filter bracket 10. Oil pressure switch 11. Oil filter 12. O-ring 13. Connecting bolt A. : To radiator lower hose B. : To water pump : N·m (kg-m, ft- ...