Nissan Juke Service and Repair Manual : P0611 ECM protection

Description

This DTC is detected when the ECM protective function is activated due to an extreme temperature increase in ECM, resulting from severe conditions such as heavy load driving.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

This DTC is displayed as protection function history. If no malfunction is detected after the diagnosis, the customer must be informed of the activation of the protection function.

>> Proceed to EC-305, "Diagnosis Procedure".

Diagnosis Procedure

1.INSPECTION START

1. Perform DTC confirmation procedure. Refer to EC-302, "DTC Logic".

2. Check 1st trip DTC.

Is DTC P0605 detected? YES >> Proceed to EC-302, "Diagnosis Procedure".

NO >> Explain the customer about the activation of the protection function.

    P0607 ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC. Is DTC detected? YES >> Proceed to EC-304, &quo ...

    P062B ECM
    Description This DTC is detected when the ECM-integrated injector driver unit has a malfunction. For injector driver unit, refer to EC-31, "ECM". DTC Logic DTC DETECTION LOGIC DTC C ...

    Other materials:

    Air fresheners
    Most air fresheners use a solvent that could affect the vehicle interior. If you use an air freshener, take the following precautions: • Hanging-type air fresheners can cause permanent discoloration when they contact vehicle interior surfaces. Place the air freshener in a location that allows i ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

    Map light control switch (if so equipped)
    The map lights control switch has three positions: ON1 , OFF2 and center. ON position When the switch is in the ON position 1 , the map lights will illuminate. OFF position When the switch is in the OFF position2 , the map lights will not illuminate, regardless of the condition. Center posi ...