Exhaust Manifold

Cylinder head

Other materials:

Engine oil
Inspection ENGINE OIL LEVEL NOTE: Before starting engine, put vehicle horizontally and check the engine oil level. If engine is already started, stop it and allow 10 minutes before checking. 1. Pull out oil level gauge and wipe it clean. 2. Insert oil level gauge and check that the engine ...

B1144 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

Final drive
Exploded View 1. Differential side bearing outer race 2. Differential side bearing 3. Final drive : Replace the parts as a set. Disassembly 1. Remove differential side bearings, using the drift (A) [SST: ST33052000] and a puller [Commercial service tool]. Assembly 1. Install different ...