Removal and Disassembly

• When instructed to use SST, use specified tools. Always be careful to work safely, avoid forceful or uninstructed operations. • Exercise maximum care to avoid damage to mating or sliding sur ...

Assembly and Installation

• Use torque wrench to tighten bolts or nuts to specification. • When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, t ...

Other materials:

B1033, B1034 crash zone sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...

CVT position
Inspection and Adjustment INSPECTION 1. Turn ON the ignition switch with the selector lever at the P position. 2. Press the selector button with the brake pedal depressed, and confirm that the lever can be shifted to positions other than P. Also confirm that shifting is not allowed from the P ...

Power steering system
WARNING If the READY to drive indicator light is off while the vehicle is in motion, the electric power assist for the steering will not be active, making the steering wheel significantly heavier and harder to operate. If the power steering warning light illuminates while you ...