Spark plug

Removal and Installation REMOVAL 1. Remove ignition coil. Refer to EM-178, "Exploded View". 2. Remove spark plug with a spark plug wrench (commercial service tool). a : 14 mm (0.55 in) ...

Drive belt idler pulley

Removal and Installation REMOVAL 1. Remove drive belt. Refer to EM-155, "Removal and Installation". 2. Remove the lock nut, and then remove the plate (7), idler pulley (6), and washer (5 ...

Other materials:

Blower fan on signal
Component Function Check 1.CHECK BLOWER FAN ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 3. Select “FAN ON SIG” in “DATA MONITOR” mode, and check status under the following condition. Is the inspection result ...

Flushing
1. Install radiator drain plug. CAUTION: Be sure to clean drain plug and install with new O-ring. Radiator drain plug : Refer to CO-17, "Exploded View". • If water drain plugs on cylinder block are removed, close and tighten them. Refer to EM-63, "Setting". 2. Remove ...

B terminal circuit
Description The “B” terminal is constantly supplied with battery power. Diagnosis Procedure CAUTION: Perform diagnosis under the condition that engine cannot start by the following procedure. 1. Remove fuel pump fuse. 2. Crank or start the engine (where possible) until the fuel pressur ...