Nissan Juke Service and Repair Manual : Wiper & Washer

Service data and specifications (SDS)
Bulb Specifications *: With intelligent key ...

Other materials:

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

P0031, P0032 A/F sensor 1 heater
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following p ...

B terminal circuit
Description “B” terminal circuit supplies power to charge the battery and to operate the vehicle’s electrical system. Diagnosis Procedure 1.CHECK “B” TERMINAL CONNECTION 1. Turn ignition switch OFF. 2. Check if “B” terminal is clean and tight. Is the inspection result normal? YES >> ...