Headlamp washer system

Wiring Diagram - HEADLAMP WASHER SYSTEM - For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "C ...

Wiper and washer system symptoms

With rain sensor WITH RAIN SENSOR : Symptom Table Without rain sensor WITHOUT RAIN SENSOR : Symptom Table ...

Other materials:

Intelligent key
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “RKE OPE COUN1” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Intelligent ...

P1078 EVT control position sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Position switch
Removal and Installation REMOVAL 1. Remove air cleaner case. (K9K) Refer to EM-280, "Removal and Installation". 2. Remove battery. (MR16DDT) Refer to PG-124, "Removal and Installation". 3. Disconnect position switch connector. 4. Remove position switch from transaxle case. ...