Nissan Juke Service and Repair Manual : Front wiper blade
Exploded View
1. Wiper blade
2. Wiper arm
Removal and Installation
REMOVAL
Push up the lever (A) of wiper blade (1), while sliding wiper blade toward the direction of the arrow to remove it from wiper arm (2).
CAUTION:
Be careful not to drop the wiper blade onto the windshield
glass.
INSTALLATION
1. Install wiper blade into wiper arm.
2. Install wiper arm.
Front wiper arm
Exploded View RHD models 1. Front wiper arm cap 2. Front wiper arm RH 3. Front wiper drive assembly 4. Front wiper motor 5. Front wiper blade LH 6. Front wiper arm LH 7. Front wiper blad ...Front wiper drive assembly
Exploded View REMOVAL LHD models 1. Front wiper arm cap 2. Front wiper arm LH 3. Front wiper blade LH 4. Front wiper arm RH 5. Front wiper blade RH 6. Front wiper drive assembly : Pawl ...Other materials:
L terminal circuit (short)
Description
The “L” terminal circuit controls the charge warning lamp. The charge warning
lamp illuminates when the ignition
switch is set to ON or START. When the alternator is providing sufficient
voltage with the engine running,
the charge warning lamp will go off. If the charge warning la ...
Thermo plunger unit
Exploded View
1. Side member LH
2. Thermo plunger control unit
3. Thermo plunger relay
4. Thermo plunger connector
5. Earth lead
6. Thermo plunger unit
7. Bracket stay
Vehicle front
: N·m (kg-m, in-lb)
Removal and Installation
REMOVAL
1. Remove battery cable from the negative ter ...
P1551, P1552 battery current sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following before conducting
the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. ...