Precaution for Procedure without Cowl Top Cover

When performing the procedure after removing cowl top cover, cover the lower end of windshield with urethane, etc. ...

Component parts

Component Parts Location 1. Light & rain sensor*1 2. Combination switch 3. Combination meter 4. BCM Refer to BCS-6, "BODY CONTROL SYSTEM : Component Parts Location". 5. IPDM E ...

Other materials:

P1723 speed sensor
Description The secondary speed sensor detects the revolution of parking gear and generates a pulse signal. The pulse signal is sent to the TCM, which converts it into vehicle speed. The prymary speed sensor detects the primary pulley revolution speed and sends a signal to the TCM. DTC Log ...

Performance test
Inspection INSPECTION PROCEDURE 1. Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge. 2. Start the engine, and set to the following condition. Test condition 3. Maintain test condition until A/C system becomes stable. (Approximately 10 minutes) 4. Check t ...

C1115 wheel sensor
DTC Logic DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT-III. 1. Stat the en ...