Nissan Juke Service and Repair Manual : Heater & Air Conditioning Control System Type 3
- How to use this manual
- Precaution
- System description
- Component parts
- System
- Operation
- Diagnosis system (BCM) (with intelligent key system)
- Diagnosis system (BCM) (without intelligent key system)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- Symptom diagnosis
- Removal and installation
Door motor
Exploded View
LEFT SIDE
1. A/C unit assembly
2. Intake door lever
3. Intake door link
4. Intake door motor
5. Air mix door motor
6. Air mix door link
7. Max. cool door
8. Upper air mix ...
How to use this manual
APPLICATION NOTICE
Information
Check the vehicle type to use the service information in this section.
...
Other materials:
P183E yaw rate sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With ...
Key warning lamp
Component Function Check
1.CHECK FUNCTION
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “INDICATOR” in “ACTIVE TEST” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Key warning lamp ...
Reverse idler shaft and gear
Exploded View
1. Reverse output gear
2. Snap ring
3. Reverse baulk ring
4. Return spring
5. Needle bearing
6. Seal washer
7. Reverse idler shaft
8. Spacer
9. Reverse input gear
10. Lock washer
11. Spring washer
: Replace the parts as a set.
: Always replace after every
disass ...
