Nissan Juke Service and Repair Manual : Front wheel hub and knuckle

Inspection

COMPONENT PART

Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.

WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)

Check the following items, and replace the part if necessary.

• Move wheel hub assembly in the axial direction by hand. Check there is no looseness of wheel bearing.

Axial end play : Refer to FAX-35, "Wheel Bearing".

• Rotate wheel hub assembly and check there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub assembly.

    Front drive shaft
    Inspection Check the following items, and replace the part if necessary. • Check drive shaft mounting point and joint for looseness and other damage. CAUTION: Replace entire drive shaft asse ...

    Other materials:

    Electric controlled coupling oil seal
    Exploded View 1. Rear final drive assembly 2. Electric controlled coupling oil seal A. Oil seal lip : Vehicle front : Always replace after every disassembly. : Apply multi purpose grease : Apply gear oil. Removal and Installation REMOVAL 1. Remove rear drive shafts. Refer to RAX-17, & ...

    Crash zone sensor
    Exploded View 1. Crash zone sensor 2. Bracket : Vehicle front : Do not reuse N·m (kg-m, ft-lb) Removal and Installation WARNING: • Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more. • Never use the air tools or electric to ...

    Engine does not start or starts with difficulty
    Description CHART 2: ENGINE DOES NOT START OR STARTS WITH DIFFICULTY Diagnosis Procedure 1.CHECK FUEL Check that the fuel reservoir is correctly filled and with the right fuel. >> GO TO 2. 2.CHECK BATTERY Check the battery. Refer to PG-124, "Removal and Installation". I ...