Compressor dose dot operate

Description SYMPTOM Compressor dose not operate. Diagnosis Procedure NOTE: • Perform self-diagnosis with CONSULT-III before performing symptom diagnosis. If any malfunction result or DTC is de ...

A/C control

Exploded View 1. Intake door cable 2. Mode door cable 3. A/C control 4. Air mix door cable 5. Intake door lever knob A. To mode door link B. To intake door link C. To air mix door link ...

Other materials:

P0112, P0113 IAT sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Writing unit parameter
Description Perform writing unit parameter of electric controlled coupling after replacing 4WD control module, rear final drive assembly or electric controlled coupling. Refer to DLN-39, "Work Procedure". Work Procedure 1.WRITE UNIT PARAMETER With CONSULT-III 1. Confirm the unit ...

U1000 can comm circuit
Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each co ...