Nissan Juke Service and Repair Manual : Thermo control amplifier

Removal and Installation

REMOVAL

1. Remove evaporator. Refer to HA-115, "EVAPORATOR : Removal and Installation".

2. Remove thermo control amp. from evaporator.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
• Replace O-ring with new one. Then apply compressor oil to them when installing.

• When install the thermo control amp., set the same position before replacement.

• When remove the thermo control amp., never turn the bracket which is equipped the top of the thermo control amp.

• Check for the leakages when recharging refrigerant. Refer to HA-74, "Leak Test".

    A/C control
    Exploded View 1. Intake door cable 2. Mode door cable 3. A/C control 4. Air mix door cable 5. Intake door lever knob A. To mode door link B. To intake door link C. To air mix door link ...

    Refrigerant pressure sensor
    Exploded View Refer to HA-94, "Exploded View". Removal and Installation REMOVAL Refer to HA-96, "REFRIGERANT PRESSURE SENSOR : Removal and Installation". INSTALLATION Insta ...

    Other materials:

    P0117, P0118 ECT sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

    Diagnosis system (BCM) (without intelligent key system)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the ...

    P0560 battery voltage
    DTC Logic DTC DETECTION LOGIC NOTE: When IPDM E/R DTC is indicated with DTC P0560, IPDM E/R DTC must be checked first. Diagnosis Procedure 1.CHECK BATTERY VOLTAGE 1. Turn ignition switch ON. 2. Check battery voltage. Voltage: Above 11 V Is the inspection result normal? YES >> GO ...