Thermo control amplifier

Removal and Installation REMOVAL 1. Remove evaporator. Refer to HA-115, "EVAPORATOR : Removal and Installation". 2. Remove thermo control amp. from evaporator. INSTALLATION Note the ...

Blower fan resistor

Exploded View 1. A/C unit assembly 2. Blower fan resistor*1 3. Sub harness*1 4. Power transistor*2 5. Sub harness*2 6. Blower motor • *1: Manual air conditioner • *2: Automatic air c ...

Other materials:

B1089 seat belt Pre-tensioner LH
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...

TCM
Exploded View 1. Bracket 2. TCM :Vehicle front : N·m (kg-m, in-lb) Removal and Installation CAUTION: When replacing TCM, note the “CVTF DETERIORATION DATE” value displayed on CONSULT-III “CONFORM CVTF DETERIORTN” in MAINTENANCE BOOKLET, before start the operation. NOTE: When ...

General Precautions
• Turn ignition switch OFF and disconnect the battery cable from the negative terminal before connecting or disconnecting the CVT assembly harness connector. Because battery voltage is applied to TCM even if ignition switch is turned OFF. • When connecting or disconnecting pin connectors ...