Operation inspection

Work Procedure The purpose of the operational check is to check that the individual system operates normally. Check condition : Engine running at normal operating temperature. 1.CHECK BLOWER MOTO ...

A/C switch

Component Function Check 1.CHECK A/C ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 3. Select “AIR COND SW” in “DATA MONITOR” mode, ...

Other materials:

P1650 starter motor relay 2
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. Models with no Intelligent Key System transmit a control signal directly to IPDM E/R. On the other hand, models with the Intelligent Key System transmit a control signal to IPDM E/R by w ...

Front wiper drive assembly
Exploded View REMOVAL LHD models 1. Front wiper arm cap 2. Front wiper arm LH 3. Front wiper blade LH 4. Front wiper arm RH 5. Front wiper blade RH 6. Front wiper drive assembly : Pawl : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) RHD models 1. Front wiper arm cap 2. Front wiper arm ...

Precaution Necessary for Steering Wheel Rotation after Battery Dis
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...