Nissan Juke Service and Repair Manual : System
- Engine control system
- Direct injection gasoline system
- Fuel pressure control
- Electric ignition system
- Intake valve timing control
- Exhaust valve timing control
- Turbocharger boost control
- Engine protection control at low engine oil pressure
- Air conditioning cut control
- Cooling fan control
- Starter motor drive control
- Evaporative emission system
- Automatic speed control device (ASCD)
- Speed limiter
- NISSAN dynamic control system
- Can communication
- Operation
- Speed limiter
- On board diagnostic (OBD) system
- Diagnosis system (ECM)
Structure and operation
Positive Crankcase Ventilation
This system returns blow-by gas to the intake manifold.
The positive crankcase ventilation (PCV) valve is provided to conduct crankcase
blow-by gas to the intake ...
Engine control system
Engine control system : System Diagram
Engine control system : System Description
ECM controls the engine by various functions.
...
Other materials:
System
WITH AUTO A/C
WITH AUTO A/C : System Diagram
WITH AUTO A/C : System Description
OPERATION DESCRIPTION
• BCM detects that the rear window defogger switch turns ON when the ignition
switch is ON, and then transmits
the rear window defogger switch signal to IPDM E/R via CAN communication for
...
High pressure fuel pump
Component Function Check
1.CHECK HIGH PRESSURE FUEL PUMP FUNCTION
With CONSULT-III
1. Start engine.
2. Check “FUEL PRES SEN V” in “DATA MONITOR” mode of “ENGINE” using CONSULT-III.
Without CONSULT-III
1. Start engine.
2. Check the voltage between ECM harness connector terminals as per the ...
Back door trim
Exploded View
1. Back door side finisher RH
2. Rear parcel shelf finisher
3. Back door side finisher LH
4. Back door lower finisher
5. Emergency lid
6. Back door pull handle
: Clip
: Pawl
Back door pull handle : Removal and Installation
REMOVAL
CAUTION:
• When removing, always use ...
