Nissan Juke Service and Repair Manual : Can communication

CAN COMMUNICATION : System Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.

Each control unit transmits/receives data but selectively reads required data only.

Refer to LAN-31, "CAN COMMUNICATION SYSTEM : CAN Communication Signal Chart", about CAN communication for detail.

    NISSAN dynamic control system
    NISSAN dynamic control system : System Diagram CVT models M/T models NISSAN dynamic control system : System Description CVT models System Description TCM transmits a drive mode select sig ...

    Operation
    AUTOMATIC SPEED CONTROL DEVICE (ASCD) AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Switch Name and Function SWITCHES AND INDICATORS 1. CRUISE indicator 2. SET indicator 3. CANCEL switch 4. RES / ...

    Other materials:

    Component parts
    Component Parts Location 1. Combination meter 2. Key switch 3. BCM Refer to BCS-96, "BODY CONTROL SYSTEM : Component Parts Location" 4. Power window main switch (door lock/unlock switch) 5. Front door switch (driver side) 6. Front door lock assembly (driver side) 7. Back do ...

    Oil filter
    Exploded View 1. O-ring 2. Oil filter bracket 3. Oil pressure switch 4. Oil filter 5. O-ring 6. Connecting bolt A. To oil cooler : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVAL 1. Using an oil filter wrench [SST:KV113C0010 (Mot.1329 ...

    P1813 4WD mode switch
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...