Nissan Juke Service and Repair Manual : Starting system

Inspection
INSPECTION AFTER INSTALLATION • With the engine running, check exhaust tube joints for gas leakage and unusual noises. • Check to ensure that mounting brackets and mounting insulators are installe ...

Other materials:

B1090, B1091, B1092, B1093, B1094, B1095 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

Checking bulbs
With all doors closed, apply the parking brake and place the ignition switch in the ON position without starting the engine. The following lights will come on: , or , , , , , The following lights come on briefly and then go off (if so equipped): , or , , , , , , , , , If ...

Blower motor
Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A, B or C). Which symptom is detected? A >>GO TO 2. B >>GO TO 11. C >> GO TO 13. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check following fuses. - 10A fuse [No. 15, located in fuse block (J/B)] - 15A fuses [Nos ...