Nissan Juke Service and Repair Manual : Inspection

INSPECTION AFTER INSTALLATION

• With the engine running, check exhaust tube joints for gas leakage and unusual noises.

• Check to ensure that mounting brackets and mounting insulators are installed properly and free from undue stress. Improper installation could result in excessive noise and vibration.

    Removal and Installation
    CAUTION: • Be sure to use genuine exhaust system parts or equivalents which are specially designed for heat resistance, corrosion resistance and shape. • Perform the operation with the exhaust sy ...

    Other materials:

    Chassis maintenance
    Headlamp aiming adjustment (halogen type - LHD) HEADLAMP AIMING ADJUSTMENT (HALOGEN TYPE - LHD) : Description PREPARATION BEFORE ADJUSTING NOTE: • For details, refer to the regulations in your own country. • Perform aiming if the vehicle front body has been repaired and/or the headlamp assemb ...

    ECU diagnosis information
    ECM Reference Value TERMINAL LAYOUT PHYSICAL VALUES NOTE: • ECM is located in the engine room left side near battery. • When disconnecting ECM harness connector (1), loosen (B) it with levers as far as they will go as shown in the figure. 2 : ECM A : Fasten • Pulse signal is measured by ...

    A/C indicator
    Diagnosis Procedure 1.CHECK SYMPTOM Check symptom. A/C indicator dose not turn ON>>GO TO 2. A/C indicator dose not turn OFF>>GO TO 6. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 10A fuse (No. 15, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Conn ...