Periodic maintenance

EXHAUST SYSTEM Inspection Check exhaust pipes, muffler and mounting for improper attachment, leaks, cracks, damage or deterioration. • If anything is found, repair or replace damaged parts. ...

Exploded View

1. Main muffler 2. Mounting rubber 3. Ring gasket 4. Center tube 5. Exhaust gas temperature sensor 2 6. Diesel particulate filter assembly 7. Gasket 8. Stud bolt 9. Diesel particulate ...

Other materials:

P182F coupling temperature sensor left
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

Rear wiper motor
Exploded View 1. Rear wiper motor 2. Rear wiper blade 3. Rear wiper arm 4. Rear wiper arm cover 5. Rear wiper pivot seal A : Model for cold areas : Pawl : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Remove rear wiper arm. Refer to WW-84, "Removal a ...

DTC/Circuit diagnosis
POSITION SWITCH BACK-UP LAMP SWITCH : Component Inspection 1.CHECK BACK-UP LAMP SWITCH 1. Disconnect position switch connector. Refer to TM-24, "Removal and Installation". 2. Check continuity between position switch terminals. Is the inspection result normal? YES >> INSPE ...